Home » Water Heating Products » Baptistry Heating » Gas Heating

Commercial Gas Water Heaters

Hotomatic® Brand Water Heater

Little Giant is proud to offer the only gas baptistry heater on the market today.  We have been manufacturing these heaters since 1904, so they are time tested and time proven.  These heaters are made of copper coils and are designed to be used on a closed loop recirculation system.  Our gas baptistry heaters have the capability of heating a 1000 gallon baptistry pool by 30 degrees in a little over three hours. 

We offer our gas baptistry heaters in two different btu ratings, 65,000btu and 120,000btu.  With the use of our circulation pump, they can be installed in the most convenient location, and the plumbing routed to the baptistry.  These gas baptistry heaters will, and can last you more than 20 years with minimal upkeep.  For the fastest and most economical way of heating, our gas baptistries heaters are the best choice.

Pump Circulation Water Heating System Installation

#2 Hotomatic

Part Number 2STD - $800.00
Pump for 2STD - $160.00

1 - #2 Heats 90 gallons per hour to a 60° rise
1 - #2 Heats 180 gallons per hour to a 30° rise
1 - #2 Heats 270 gallons per hour to a 20° rise

Pump Circulation Baptistry Water Heating Installation

Instantaneous Water Heating System Installation

#3 Hotmatic

Part Number 3STD - $950.00
Pump for 3STD - $160.00

1 - #3 Heats 150 gallons per hour to a 60° rise
1 - #3 Heats 300 gallons per hour to a 30° rise
1 - #3 Heats 450 gallons per hour to a 20° rise

Pump Circulation Baptistry Water Heating Installation

Caution!

Heater and all pipe work must be below the baptistry water level.
Do not ignite heater until heating system is full of water and circulation is started.
Heater and pump must be turned off prior to draining baptistry.

Important

To prevent coil sweating it is necessary to reduce the rate of water circulation. This can be done by installing a valve in the circulation line. Simply close down on the valve until water condensation stops accumulating on the heater coils.

Heater, pump and pipe work can be installed beside the baptistry wall. Piping, pump and aquastat must be below baptistry water level with no air traps.

Note

Heater, pump and pipe work can be installed beside the baptistry wall. Piping, pump and aquastat must be below baptistry water level with no air traps.

Contact one of our qualified representatives today to discuss options and pricing
or to order from the number-one fiberglass church manufacturer in the U.S. call us today at 1-800-231-6035


Internet marketing and web development
by TopSpot Internet Marketing