Electric Immersion Water Heater 240 Volts
Model SS-6-42HL
240 Volts Single Phase
Especially Designed For Easy, Low Cost Installation
Applications:
The SS-6-42HL unit is ideally engineered for Fast Heat-Up in
Water - Alkaline - Plating - Bath Heating
Construction Features
- Immersion section of unit made of Incoloy or Stainless Steel.
- All heat confined to the formed horizontal section for optimum heat efficiency.
- Cold riser extends to the top of container where control housing is located.
- 3-Conductor cord set with polarized plug included for easy installation and wiring at
no extra charge.
- Adjustable vapor-proof thermostat control with temperature range off - 55°F to 115°F (± 3°).
- Hi-Limit cut out switch set at 125°F (±4°).
- Stainless steel mounting bracket also supplied for easy mounting.
- Pilot light and on-off switch provided, indicates desired temperature when reached
and breaks circuit when element is not in use. Saves electricity - Saves money.
Notes:
- Completely automatic and portable - just plug in 42" Power Cord and operate.
- No cutting or damage to your present container.
- Although portable - your container may be cleaned without removing unit.
- Unit can be suspended in middle, end or side of container.
- No contractors required on standard SS-6-42HL Models
- The SS-6-42HL (6KW) will heat 60 GPH (40° R). A 750 to 1,000 gallon Baptistry can
be heated in 13 to 17 hours, or one-half this time 20 degree rise in temperature.
- Heater can be operated on 120 volts, but power will be reduced to 1.5KW and will heat 15 GPH (40°R) or 30 GPH (20°R)
UL Listed under File # E234452
Model SS6-42HL [Part No. 6HI-HL] List Price $410.00
Receptacle [Part No. SR] List Price $45.00
Surface or Flush Mounted
Electric Immersion Water Heater 120 Volts
Model # 6HI-HL-120
120 Volts Single Phase
Especially Designed For Easy, Low Cost Installation
Applications:
The 120 volt immersion heater is perfect for portable baptisteries, where the heater is taken into and out of the baptistery.
Construction Features
- Immersion section of unit made of Incoloy Stainless Steel.
- All heat confined to the formed horizontal section for optimum heat efficiency.
- Cold riser extends to the top of container where control housing is located.
- 3-Conductor cord set with polarized plug included for easy installation and wiring at no extra charge.
- Adjustable vapor-proof thermostat control with temperature range off - 55°F to 115°F (± 3°).
- Hi-Limit cut out switch set at 125°F (±4°).
- Stainless steel mounting bracket also supplied for easy mounting.
- Pilot light and on-off switch provided, indicates desired temperature when reached and breaks circuit when element is not in use. Saves electricity - Saves money.
Notes:
- Completely automatic and portable - just plug in 42" Power Cord and operate.
- No cutting or damage to your present container.
- Although portable - your container may be cleaned without removing unit.
- Unit can be suspended in middle, end or side of container.
- No contractors required for ease of installation.
- The 6HI-HL-120 (1.5KW) will heat 20 GPH (40° R). A 100 to 200 gallon Baptistry can be heated in 5 to 10 hours, or one-half this time for 20 degree rise in temperature.
- Heater must be used with a GFCI to comply with NEC codes.
UL Listed under File # E234452
Model [Part No. 6HI-HL-120] List Price $410.00